IKEA LAGAN Bedienungsanleitung Seite 6

ENGLISH
Filling the rinse aid dispenser
Rinse aid makes dish DRYING easier. The rinse aid dispenser
should be filled when when the dark optical indicator on the
dispenser door becomes transparent
C
C
B
1. Open the dispenser by pressing and pulling up the tab on
B
the lid.
2. Carefully introduce the rinse aid as far as the maximum (110
ml) reference notch of the filling space ­ avoid spilling it. If this
happens, clean the spill immediately with a dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the tub.
Adjusting the dosage of rinse aid
If you are not completely satisfied with the drying results, you
can adjust the quantity of rinse aid used.
• Switch the dishwasher on using the ON/OFF button.
• Switch it off using the ON/OFF button.
• Press button three times ­ a beep will be heard.
• Switch it on using the ON/OFF button.
• The program indicator light of the current set level flashes.
• Press button to select the level of rinse aid quantity to be
supplied.
• Switch it off using the ON/OFF button.
Setting is complete!
If the rinse aid level is set to 1 (ECO), no rinse aid will be
supplied. The LOW RINSE AID indicator light will not be lit if you
run out of rinse aid. A maximum of 5 levels can be set according
to the dishwasher model. The factory setting is specific to the
model, please follow instruction above to check this for your
machine.
• If you see bluish streaks on the dishes, set a low number (2­3).
• If there are drops of water or limescale marks on the dishes,
set a high number (4­5).
Control panel
1 2 3
1 On­Off/Reset button with indicator light
2 Program selection button
3 Salt refill indicator light
4 Program indicator lights
5 START/Pause button with indicator light
A
.
A
4
50° 45° 65° 55°
4
To download the full version visit www.ikea.com
Filling the detergent dispenser
Usage of detergent not designed for dishwashers may cause
malfunction or damage to the appliance.
To open the detergent dispenser press button
Introduce the detergent into the dry dispenser
Place the amount of detergent for pre-washing directly
inside the tub.
E
D
1. When measuring out the detergent refer to the mentioned
earlier information to add the proper quantity. Inside the
dispenser there are indications to help the detergent
E
dosing.
2. Remove detergent residues from the edges of the dispenser
and close the cover until it clicks.
3. Close the lid of the detergent dispenser by pulling it up until
the closing device is secured in place.
The detergent dispenser automatically opens up at the right
time according to the program.
45°
5
6
.
D
only.
E
5 PROGRAMS