Sunrise Medical EASY 160 Gebrauchsanleitung Seite 19

Options – Amputee Axle Plate
Amputee Axle Plate
The larger the wheel base is, the
greater is the stability of the wheel-
chair. The wheel base can be
extended by screwing the axle
sleeve (1) onto the frame at the
desired height. Make sure that the
steel pin (2) is mounted correctly in
the hole drilled in the frame for this
purpose. When finished, make
sure that all screws have been
properly tightened (see the page
on torque).
CAUTION:
Wheel locks must be adjusted
for the new position.
Options – Sideguards
Sideguards
Standard Sideguard, Flip-Up,
Detachable with Short or Long
Armrests
The front of the sideguard is
angled downward, which allows
you to pull up close to a desk or
table top. To flip the guard up,
push the lever (1) forward to
unlock the sideguard. The height
of the armrest (2) can be adjusted
by installing the spacers (3) in one
of several positions. To do so, you
must first loosen the screws (4),
switch the spacers (3) and then
retighten the screws (4) (see the
page on torque).
CAUTION:
Neither the sideguards nor the
armrests are to be used for lif-
ting or carrying the wheelchair.
Desk Sideguard, Flip-Up,
Detachable with Short or Long
Armrests, Height-Adjustable
Adjust the height of the armrest as
follows: Slide the knob (1) forward
until it stops. Adjust the armrest (2)
to the desired height. Slide the
knob toward the back and push
the armrest (2) down until you can
hear it click into place. Always
make sure that the sideguards
have locked into place properly. To
flip the armrest up, lift the handle
(3) to unlock the sideguard.
1
2
2
3
4
1
2
1
3
CAUTION:
Neither the sideguards nor the
armrests are to be used for
lifting or carrying the wheelchair.
Sideguards - Clothing Guards
Clothing guards prevent water
from splashing up and soiling
clothing. Their position relative to
the rear wheels can be set by
adjusting the sideguards. To do
this, remove the screws (1 and 2).
After adjusting the sideguards to
the desired position, replace and
retighten the screws (see the page
on torque).
CAUTION:
Neither the sideguards nor the armrests are to
be used for lifting or carrying the wheelchair.
Options – Push Handles
Height-Adjustable Push Handles
These handles are secured with
pins to prevent them from sliding
out unintentionally. Opening the
quick-release lever (1) makes it
possible to adjust the push hand-
les to meet your individual needs.
As you move the lever, you will
hear a locking mechanism; you
may now easily position the push
handle as desired. The nut (2) on
the tension lever determines how
tightly the push handles are
clamped into place. If the nut is loose after adju-
sting the tension lever, the push handle will also be
too loose. Turn the push handle from side to side
before use to make sure that it is clamped securely
enough into place. After adjusting handle height,
always clamp the tension lever (1) securely into
place. If the lever is not secure, injuries could result
when lifting over obstacles.
Options – Seat Belt
Seat Belt
The seat belt is a hip belt that
enhances wheelchair safety. The
seat belt is fastened to the frame
as shown in the picture.
2
1
3
1
2
1
19
EASY 160, 160 HP