Herunterladen Diese Seite drucken

Kärcher SC 1122 Plus Bedienungsanleitung Seite 21

Werbung

Manual nozzle (E1)
Pull the terry cloth cover (E2) over the man-
ual nozzle.
Application:
– small, washable surfaces, such as
kitchen surfaces made of plastic, tiled
walls
– Shower cabins, mirror
– Furniture fabrics
– Vehicle interior, windshields
– Bath-tubs
Micro-fibre abrasive cloth (E3)
Pull up the micro-fibre abrasive cloth over
the hand nozzle.
Application:
– Removing calcium and soap residues in
the bath-room (for e.g shower cabins,
tiled walls).
– While cleaning mirrors, we recommend
that you polish again using a micro-fibre
cloth (micro-fibre set of dusters "Bath",
order no. 2.863-171).
Can be washed at 60 °C; please do not use
any soft detergents. Not suitable for drier.
Squeegee (F1)
Application:
– Windows, mirrors
– Glass surfaces on showers
– other smooth surfaces
Perform a fat dissolving basic cleaning
using the manual nozzle (E1) and a ter-
ry cloth cover (E2) before the first clean-
ing using the window nozzle.
Apply steam to the glass surface from a
distance of approximately 20 cm until
the surface is moistened evenly.
Strip the glass surface in straight lines
from the top to the bottom using the rub-
ber lip of the window nozzle. Wipe the
rubber lip and the bottom edge of the
window dry after each strip.
Floor nozzle (H1)
Application:
– all washable wall and floor coverings,
e.g.: Stone floors, tiles, and PVC floors.
Attach the floor cloth to the floor nozzle.
1 Fold the floor cloth the long way and
place the floor nozzle on top of it.
2 Open holding clamps.
3 Place the cloth ends into the openings.
4 Close the holding clamps.
Caution
Do not insert fingers between the clamps.
To remove the cloth, press the retaining
clips (H2), and pull out the cloth.
Turn and exchange the floorcloth in reg-
ular intervals. Thus, you improve the
ability to pick up dirt.
Work slowly on very dirty surfaces to al-
low the steam to act on the dirt for a
longer period of time.
If there are residues of detergents or
floor cleaning products (e.g. wax, liquid
polish) on the surface to be cleaned,
streaks may form during the cleaning.
These streaks normally disappear after
a repeated use of the steam cleaner.
Figure 4
21
English

Werbung

loading