Werbung
Operation
Attaching the Accessories
Tightly insert the steam plug (C6) into
the appliance connector (A1). The plug
must click into place audibly.
Connect the required accessories to the
steam gun (C1). Insert the open end of
the accessory on the steam gun and
push onto the steam gun until the un-
locking button (C2) of the steam gun
locks into place.
Use the extension pieces (G1) if neces-
sary. To do so, connect one or both ex-
tension pieces to the steam gun (C1).
Insert the required accessories on the
free end of the extension piece.
Removing the Accessories
DANGER
Hot water may drip out of the accessory
parts while you are detaching them! Never
detach accessory parts while steam
streams out - risk of scalding!
Push the lock (C3) to the front (steam
switch blocked).
To detach the accessory parts, press
the unlocking button (C2 or G2), and
pull the items apart.
18
English
Note: If you always use usual commercial
distilled water it is not necessary to descale
the boiler.
CAUTION
Do not use condensation water from the
drier! Do not fill in detergents or other addi-
tions!
Remove the safety clamp (A3) from the
device.
Empty remaining water from boiler.
Figure 1
Fill the boiler with a maximum of 1.2 lit-
ers of fresh tap water.
Note: The boiler can be filled up to 2 cm
below the edge of the filler neck. You
can cut down the heating-up time by us-
ing warm water.
Screw the safety clamp (A3) back onto
the device.
Turning on the Appliance
Place the unit securely on a firm sur-
face.
Note: Do not carry the unit while clean-
Figure 2
ing.
CAUTION
Do not turn the appliance on without water
in the boiler. Otherwise, the appliance may
overheat (see troubleshooting).
Insert the mains plug into a socket.
Press the switch (A2) to turn on the ap-
pliance.
The orange indicator lamp glows.
The orange indicator lamp (B2) goes
out after approximately 8 minutes.
The steam cleaner is ready to use.
Push the steam switch lock (C3) to the
back.
Fill up with water
Figure 3
Werbung
