Rimage Prism III Bedienungsanleitung Seite 21

Maintain the Prism III Printer
3. Clean the front two ribbon guides.
a. Apply isopropyl alcohol to a clean cotton swab.
b. Run the swab against the ribbon guides to clean them.
4. After the alcohol on the print head dries, prepare the Prism for use.
a. Install the ribbon. Refer to the
page 18.
b. If your removed the printer from an autoloader or AutoPrinter,
place the printer on the system and connect all cables and cords to
the back of the printer. Refer to the
Printer section on page 6.
Change the Print Ribbon
Important! The Prism III printer only operates with genuine Rimage ribbons.
Rimage supports only the use of Rimage brand ribbons in our printers.
Printer issues that occur as a result of using ribbons by manufacturers other
than Rimage are not included under your Rimage warranty or maintenance
agreement.
Tip: If ribbons are stored in an environment much different from that of the
printer, allow time for them to become acclimated to the new environment.
Allow more time for greater temperature and/or humidity differences.
1. Access the ribbon area.
a. Power on the Prism.
b. Remove the top
cover from the
printer.
c. Lift up the take-up
roller so that the
end with the gear
comes up first,
then lift the take-
up roller out of the
Take-up Roller
printer.
2001809_A
Change the Print Ribbon section on
Identify the Parts of the Prism
Supply Roller
For more information visit
d. Lift up the supply roller to remove it.
Note: If you are replacing the ribbon, now is a good time to clean the
print head. Refer to the Clean the Print Head
2. Load the print ribbon.
a. Slide the print ribbon onto the supply roller.
b. Align the two notches of the cardboard core with the metal pins on
the supply roller.
Print Ribbon
Cardboard Core
Metal Pins
Supply Roller
c. Press the operator button to close the print tray.
d. Peel the ribbon leader from the supply ribbon.
e. Slide the ribbon leader under the ribbon guide and into the ribbon
installation clamp.
Ribbon Installation
Clamp
Printer Tray
rimage.com/support
section on page 16
Notches
Ribbon Guide
Ribbon Leader
18