Rimage Prism III Bedienungsanleitung Seite 20

Maintain the Prism III Printer
4. Clean the print head.
a. Press the operator button to close the printer tray and start the
cleaning cycle. When the cleaning cycle is complete, the printer tray
opens.
b. If necessary, repeat step a to begin the cleaning cycle again.
c. When the print head is clean, remove the cleaning pad and
attached disc from the printer tray.
5. Clean the front two ribbon guides.
a. Apply isopropyl alcohol to a clean cotton swab.
b. Run the swab against the ribbon guides to clean them.
6. Prepare the Prism for use.
a. Press the power switch off and on to exit cleaning mode and reset
the printer.
b. Reinstall the ribbon. Refer to the
page 18.
c. If you removed the printer form an autoloader or AutoPrinter, place
the printer on the system and connect all cables and cords. Refer to
the Identify the Parts of the Prism III Printer
Note: If the printing pad on the tray is wet from cleaning, allow the
printing pad to completely dry before using the Prism.
2001809_A
Front Ribbon
Guides
Cleaning Pad
Cleaning
Solution
Change the Print Ribbon
section on
section on page 6
For more information visit
Clean the Print Head – Alternate Method
If a cleaning kit is not available, use the following procedure to clean the
Prism print head.
# Required tools:
99% Isopropyl alcohol
•
Cotton swabs
•
1. Prepare the Prism III.
a. Power on the Prism III.
b. Press the operator button to open the printer tray.
c. Power off the Prism III.
d. Remove the top cover.
e. Remove the ribbon. Refer to the
page 18.
2. Clean the print head.
a. Apply isopropyl alcohol to a cotton swab.
b. Insert the cotton swab into the drawer opening.
c. Lift the swab upward as you run the swab against the convex
surface of the print head.
Important! The bottom of the print head is shown to illustrate the area to
clean. Do not remove the print head from the printer.
rimage.com/support
Change the Print Ribbon section on
Convex Surface of Print Head
17