Rimage Prism III Bedienungsanleitung Seite 22

Maintain the Prism III Printer
3. Install the supply roller as shown. Leave some slack in the ribbon leader.
a. Press the
operator button
until the printer
tray comes out.
The ribbon is
threaded to
Supply Roller
the front of the
Prism.
b. Remove the
ribbon leader from the installation clamp.
c. Remove the adhesive strip from the ribbon leader.
4. Load the take-up roller.
a. Place the new empty cardboard core on the take-up roller. It is
designed to fit only one way.
b. Place the take-up roller on top of the ribbon leader as shown.
Important! The gear must be on the correct side.
Adhesive Strip
2001809_A
Cardboard Core
Gear
Ribbon Leader
For more information visit
c. Pull the ribbon leader up
over the cardboard core.
d. Attach the adhesive
strip to the cardboard
core so that the edges
on the ribbon leader are
aligned to the edges of
the cardboard core.
e. Roll the ribbon leader so
that it is wrapped only
once around the roller.
Important! Do not roll past the marking on the leader that states
STOP - Wind Leader Onto Take-up Core Stopping Here for
monocolor ribbons. If you are using a CMY ribbon, roll up to the end
of the yellow leader.
rimage.com/support
19