Parkside PDSP 1000 E6 Originalbetriebsanleitung Seite 6

WARNING!
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure speci-
fied in EN ISO 20643 and can be used to
make equipment comparisons. The specified
vibration emission value can also be used to
make an initial exposure estimate.
The vibration level varies in accordance with
the use of the compressed air tool and may
be higher than the value specified in these
instructions in some cases. It is easy to under-
estimate the vibration load if the compressed
air tool is used regularly in a certain manner.
NOTE
► For an accurate estimate of the vibration load
during a specific working period, the periods
during which the appliance is switched off or
is running but not actually being used must
also be taken into consideration. This can
significantly reduce the vibration load over
the total working period.
General safety
WARNING!
information
WARNING!
► Read all safety warnings and all instructions.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
Workplace safety
a) Keep work area clean and well lit. Cluttered
or dark areas invite accidents.
b) Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Appliance
can create sparks which may ignite the dust or
fumes.
b) Keep children and bystanders away while
operating a tool. Distractions can cause you to
lose control.
PDSP 1000 E6
Device-specific safety instructions
for compressed air sandblasters
■ Check the appliance for any possible defects
before use. If the appliance exhibits any faults,
it should not be used under any circumstances.
■
Keep children and bystanders away while
operating the tool. Distractions can cause you
to lose control.
■ RISK OF INJURY! MISUSE! Do not point the
tool towards people or animals!
■
Wear a dust mask!
■ Wear safety goggles!
■ Wear protective gloves!
■ Wear suitable protective clothing.
■ Wear safety shoes!
■
Wear a safety helmet!
■ RISK OF EXPLOSION! The compressed air
sandblaster gun should not be used in areas
with gas/open flames/fire/gas-operated
water heaters.
■ SMOKING PROHIBITED!
■
Work only in sufficiently ventilated rooms.
■ Do not use oxygen or any combustible gas as
an energy source.
■ Never exceed the maximum operating pressure
of 6.3 bar.
WARNING!
► KICKBACK FORCES! At high working pres-
sures, kickback can occur which can, under
certain circumstances, lead to danger due to
continuous loads.
■ RISK OF INJURY! Disconnect the appliance
from the compressed air source before starting
any repairs or maintenance work and before
transportation.
■ RISK OF INJURY! Disconnect the appliance
from the compressed air source before refilling
the blasting medium.
GB │ IE │ 3 ■