Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MAINTENANCE SCHEDULE
Perform at every indicated month/year or operating hour interval,
whichever comes first.
Regular Service
Period
Before each use
Check: Grass catcher
Check: Cutting means
Check: Operation of the cutting
Check: Engine oil level
Check: Air filter
Check: Rear shield
Check: Cutting-means bolts
First month
Change: Engine oil
or 5 hours
First 25 hours
Clean: Air filter
Adjust: Smart Drive cable
Adjust: Roto-Stop cable (VYEA)
Adjust: Throttle cable (VYEA)
Every 6 months
Change: Engine oil
or 50 hours
Clean: Air filter
Adjust: Smart Drive cable
Every year
6 month items above plus:
or 100 hours
Check-adjust: Spark plug
Clean: Spark arrester
Check: Operation of the
Grease: Pinion gears
Adjust: Valve clearance
Adjust: Roto-Stop cable (VYEA)
Adjust: Throttle cable (VYEA)
Clean: Fuel tank
Every 2 years
Yearly items above plus:
or 150 hours
Replace: Air filter
Replace: Spark plug
Adjust: Smart Drive cable
Check: Transmission axle bearings
Every 2 years
Check: Fuel lines replace if
necessary
1. Service more frequently when used in dusty areas.
2. These items should be serviced by an authorized Honda servicing
dealer, unless you have the proper tools and are mechanically
proficient. Refer to the Honda shop manual for service procedures.
3. In Europe and other countries where machinery directive
2006/42/EC is enforced, this cleaning should be done by your
servicing dealer.
Failure to follow this maintenance schedule could result in
non-warrantable failures or reduction in performance and emissions
noncompliance.
12
Item
means-control
1
2
2
2
1
1
2
3
(if equipped)
cutting-means control
2
2
2
2
2
2
2
2
ENGINE MAINTENANCE
Engine Oil Change
Drain the oil while the engine is warm. Warm oil drains quickly and
Page
completely.
1. Turn the fuel valve OFF. This will reduce the possibility of fuel
page 14
leakage (page 5).
page 6
2. Wipe the oil filler area clean, and then remove the oil filler
cap/dipstick.
page 5
3. Place a suitable container
page 7
next to the mower to catch
page 7
the used oil, and then tilt
page 8
the mower on its right side.
page 14
The used oil will drain
page 12
through the filler neck.
Allow the oil to drain
completely.
page 13
Please dispose of used
motor oil and the
containers in a manner that
is compatible with the
environment. We suggest
page 12
you take it in a sealed container to your local recycling center or
page 13
service station for reclamation. Do not throw it in the trash, pour it
on the ground or pour it down a drain.
4. Fill with the recommended
page 13
oil (page 7). Do not overfill.
page 13
Measure the oil level as
shown below.
page 5
Refill Amount:
0.35~0.40 L
5. After changing the engine
oil and before starting the
engine, check the oil level
with the mower on a level
surface:
page 13
a. Remove the filler
page 13
cap/dipstick [1].
b. Wipe the dipstick clean.
c. Insert and remove the
dipstick without
screwing it into the filler
neck. Check the oil
level shown on the
dipstick.
d. If the oil level is below
the low level mark [3],
add oil to reach the high
limit mark [2] on the
dipstick. Do not overfill.
If the engine is
overfilled, the excess oil
may get transferred to
the air cleaner housing
and air cleaner filter.
NOTICE
Running the engine with a low oil level can cause engine damage.
e. Screw in the filler cap/dipstick securely.
ENGLISH
[1]
[2]
[3]
Werbung
