Werbung
-} BS = Fe C0 |
nN
Start-stop
rod
DISASSEMBLY INSTRUCTIONS
How to remove the bottom board and
automatic mechanism plate
. Fix the tonearm on the rest.
. Remove the turntable.
. Close the dust cover, and turn over the unit, taking
care not to scratch it.
. Remove
the bottom
board setscrews |) ~ ©. Then
the bottom board can be removed. (See Fig. 1)
. Remove the setscrews Q)~@in the automatic mecha-
nism plate and take off the start-stop rod, then the
automatic mechanism plate can be detached.
3
.
'
/
Shield plate
Automatic mechanism plate
Fig. 2
How to remove the drive circuit P.C.B. and
motor
. Remove
the bottom
board.
(Refer to 'How
to re-
move
the bottom
board
and automatic
mechanism
plate''.)
. Remove
the AC cord clamper and disengage the set
screws
@
to ® of the drive circuit P. C. B, then
the P. C. B. can be detached.
(See Fig. 3 )
. Disengage the motor bracket fitting screws
®
j @®
and disconnect the soldered motor terminals
®@ '
@
then the motor can be detached. (See Fig. 4 )
. For assembling, mount the motor so as the arrow on
Fig. 4 comes to the position of hall 1C (1C 1).
Bottom board
Drive circuit P.C.B.
Fig. 3
# @
"s
.
.
.
Drive circuit
@
P.C.B.
~~ Motor assy
~~~ Bracket
Werbung
