Panasonic WH-WDG05LE5 Installationsanleitung Seite 9

CONNECT THE CABLE TO THE OUTDOOR UNIT
4
(FOR DETAIL REFER TO WIRING DIAGRAM AT UNIT)
1. Attach the discharge grille (left side) 3 for safety before connecting the cable.
2. Connecting cable between indoor unit and outdoor unit shall be approved polychloroprene sheathed fl exible cable (see below table), type
designation 60245 IEC 57 or heavier cable. Sheath diameter of connecting cable shall be within specifi cation (see below table) to fi t cable gland.
Flexible cable specifi cation
2
4 × min 2.5mm
3. Route the cable as follows
1
* Locally procured cabtyre cables with the specifi ed diameter.
2
* Must be fastened with the specifi ed torque Viewpoint of gas intrusion prevention.
1 Remove the front plate (Fig. 4-1)
2 Remove the terminal cover and cable gland cap (Fig. 4-2)
3 Insert the cabtyre cable *1 (Fig. 4-3, 4-4)
(Pulled in from the rear panel and inserted from the bottom of the electric controller BOX)
4 Connect to terminal block (Fig. 4-5)
5 Fasten the cable gland *2 (Fig. 4-4)
6 Set the terminal cover *2 (Fig. 4-2)
7 Set the front plate (Fig. 4-1)
Fig. 4 - 1
From
Indoor unit
The nut does not need to be removed.
If accidentally the nut is removed, fasten to
the following torque.
Tightening torque : 220 ~ 300 cN•m
Pass the cable through the cable gland.
Screw 5 in 4 places
4 claw hooks
Cable diameter
ø12.0-14.0
Tightening torque :
147.1 ~ 245.2 cN•m
(15 ~ 25 kgf•cm)
The cabinet top plate does not need to be removed.
Fig. 4 - 3
(22.43 ~ 30.59 kgf•cm)
Fig. 4 - 4
Terminal cover
Fig. 4 - 2
Fasten with
the cable tie.
Fasten the cable gland
Tightening torque :
180 ~ 250 cN•m
(18.35 ~ 25.49 kgf•cm)
Cable gland
Cable gland
cap disposal
Pass the cable
through the groove.
Cabtyre cable
If it is diffi cult to pass
the cable through, the
cover can be removed.
9