Panasonic WH-WDG05LE5 Installationsanleitung Seite 10

1 2
WIRE STRIPPING AND CONNECTING REQUIREMENT
Wire stripping and crimp a ring
terminal to the wire
PIPE INSULATION
5
1. Please carry out insulation at pipe connection portion as mentioned in Indoor/Outdoor Unit Installation Diagram. Please wrap the
insulated piping end to prevent water from going inside the piping.
INSTALL THE DISCHARGE GRILLE
6
1. Remove the 3 screws fastened to the cabinet front plate. (Fig. 6-1)
2. Insert 4 claws of the discharge grille (right side) 4 and fasten the 3 screws. (Fig. 6-2)
Make sure to install the discharge grille to the outdoor unit before
powering ON to protect againts a rotating fan.
If cleaning of the outdoor unit is necessary during installation or servicing,
do not clean the outdoor unit with any hydrocarbon based solvent.
10
Screw
3
Earth Wire
must be longer
than other
wires for safety
reason.
Cable gland
Inner diameter: Ø5.2 or more
Outer diameter: Ø12.5 or less
CAUTION
Remove the
3 screws
Fig. 6-1
CAUTION
Terminals on the indoor unit
Colour of wires
Terminals on the outdoor unit
Terminal screw
Fig. 4 - 5
Insert 4 claws
Fig. 6-2
WARNING
This equipment must be
properly earthed.
1 2 3
1 2 3
Tightening torque
cN•m {kgf•cm}
M4 157 ~ 196 {16 ~ 20}
M5 196 ~ 245 {20 ~ 25}
Indoor/outdoor
connecting
terminal board
5 mm or more
(gap between wires)
Fasten the
3 screws