Fronius CrashBox Robacta Drive CMT-PAP Installationsanleitung Seite 8

General
General
Device concept The CrashBox Robacta Drive CMT PAP has been specifically designed for moun-
ting on the robot arm and for holding gas-cooled and water-cooled Robacta Drive
CMT PAP drive units. The welding torch hosepack runs through the CrashBox
and then through the robot arm.
Scope of supply
8
(1) (2) (3)
The CrashBox Robacta Drive CMT PAP
is a safety device used in robot wel-
ding.
In the event of a collision, the Crash-
Box sends a signal to the robot control,
which stops the robot immediately.
The spring-mounted torch holder on
the CrashBox protects the CMT PAP
drive unit from damage should a colli-
sion occur, provided the permitted
CrashBox deflection is not exceeded
(see "Technical data"). It is reset to the
original position after a collision.
(1) 1x safety clamp, front
(2) 2x Allen screws, M5 x 16 mm
(4)
(3) 1x CrashBox Robacta Drive
CMT PAP
(4) 1x safety clamp, rear