Werbung
6.2.3. 4G configuration
1.
Under Software setting, navigate to 4G configuration
2. Click „Enable modification"
3. Set APN, User, Psw, Pin according to actual usage (depending on the SIM card service
provider)
4. Click „Submit" to confirm and wait for the "Success" confirmation
5. Upon "Failure" confirmation, wait a few seconds and click "Submit" again
6.2.4. Ethernet configuration
1.
Under Software setting, navigate to Ethernet configuration
2. Click „Enable modification"
3. Click „DHCPC Enable"
4. Click „Submit" to confirm and wait for the "Success" confirmation
5. Upon "Failure" confirmation, wait a few seconds and click "Submit" again
© 2023 Maxeon Solar Technologies, Ltd. All rights reserved. | 549549 Revision A - October 2023
Specifications included in this document are subject to change without notice
23
Werbung
