Werbung
6.2.1. Network Priority Settings
For Drive, you can use one, two or all three communications methods to connect to the internet.
Setting up a priority will determine which is the main connectivity method, and which are the
backup options. Always select three, even if only one is used.
1.
Under Software setting, navigate to Network priority selection
2. Click "Enable workmode"
3. The available selection is Wlan (for Wi-Fi), Eth0 (for Ethernet / LAN) and 4G
4. Select Priority 1 / 2 / 3 depending on the preferred internet connection method used
5. Click "Submit" to confirm and wait for the "Success" confirmation
6. Upon "Failure" confirmation, wait a few seconds and click "Submit" again
6.2.2. Peak Controller
Only if the Peak Controller Accessory has been installed, follow the following steps for the com-
missioning of the Peak Controller.
1.
Under Software setting, navigate to Modbus tcp
2. Enter port number 502 under „port"
3. Select "pct" under "mode select"
4. Set "safe current (unit: A)" limit to "6"
5. Click „Submit" to confirm and wait for the "Success" confirmation
6. Upon "Failure" confirmation, wait a few seconds and click "Submit" again
© 2023 Maxeon Solar Technologies, Ltd. All rights reserved. | 549549 Revision A - October 2023
Specifications included in this document are subject to change without notice
22
Werbung
