Werbung
If the solid cable is used as power cable, remove the original screws on the terminal
7
block and install the screw-clamp to connect the power cable, shown as Figure 9. Solid
cable doesn't require crimping ring terminals
8
Fix the cables by the plastic cable clamp, as shown in Figure 10
9
After completing the wiring, insert the SIM card, as shown in Figure 11
10
Close the rear cover, as shown in Figure 12.
Figure 11 Inserting the SIM card
© 2023 Maxeon Solar Technologies, Ltd. All rights reserved. | 549549 Revision A - October 2023
Specifications included in this document are subject to change without notice
Figure 9 Installing screw-clamp
Figure 10 Plastic cable clamp
PH2
Figure 12 Closing the rear cover
17
Werbung
