Werbung
Control the cable inlet length and stripping length according to the requirements in
Figure 6. The power cable is a flexible cable, which needs to be crimped with a ring
4
terminal. CAT5 or CAT6 cable can be used as network cable, and the network cable is
crimped with the network cable connector.
7.4kW
Network cable
The power cable needs to be crimped with the ring terminal. The crimping process is
5
shown in Figure 7.
Step 1
Install the cable inlet rubber plug and complete wiring operation, as shown in Figure
6
8. Complete power cable wiring, then connect the network cable if necessary. External
grounding is not required.
© 2023 Maxeon Solar Technologies, Ltd. All rights reserved. | 549549 Revision A - October 2023
Specifications included in this document are subject to change without notice
Power cable
Figure 6 Cable inlet length (Unit: mm)
Step 2
Figure 7 Ring terminal crimping
7.4kW
Figure 8 Wiring diagram
22kW
Network cable
Step 3
22kW
Power cable
Step 4
16
Werbung
