Nilfisk SC3500 Bedienungsanleitung Seite 9

SC3500 QUICK START GUIDE
CONTROL PANEL (as shown in Figure 2)
30
31
32
33
34
35
30. LCD screen
31. Speed controller light
32. Detergent flow control knob (*)
33. Solution volume adjusting button (- +)
34. Horn button
35. Forward-Backward switch
36. Recovery tank full indicated light
37. Front lights
38. Brush pressure indicated light
39. One-Start button
40. Vacuum system switch
41. Brush unload button
42. Speed adjusting knob
DISPLAY WINDOW OF CHARGER INDICATON LIGHT (as shown in Figure 2)
1. At the beginning of charging, the red LED (53) of charger normally on. It is the first stage of charging.
2. After charging some time, the red LED (53) turns off, the yellow LED (52) turns on, this is the second stage of
charging.
3. After charging finish, the yellow LED (52) off, the green LED (51) turns on to indicate that the battery is fully
charged.
NOTE
When charging, if the yellow LED (52) of charger is on, it may be caused by: Battery and
charger does not match, battery is not connected well, or output is short-circuited.
The red LED of charger flashing may be caused by charger internal short circuit. (For details
refer to the "Battery charging" section of the Instruction for Use manual)
49
47 48
36
43
37
38
39
40
44
41
45
42
46
Figure 2
43. Charger plug cover
44. Vacuum motor overload protector
45. Drive motor overload protector
46. Brush lift overload protector
47. Brush motor overload protector
48. Main motor overload protector
49. Brush motor overload protector
50. Squeegee lift overload protector
51. Charger plug
52. Battery fully charged indicator (Green)
53. Battery semi-charged indicator (Yellow)
54. Battery charge indicator (Red)
(*): Optional
5
50
51
ENGLISH
52
53
54