Nilfisk SC3500 Bedienungsanleitung Seite 14

SC3500 QUICK START GUIDE
6. You can charge your phone or pad through USB charging port (K Figure7) when the key switch (A Figure7) is
turned to "ON".
7. Press the horn button (H Figure7) to warn people when necessary.
8. If necessary, press the emergency button(M Figure7) for machine emergency stop.
NOTE
The brush motor, vacuum motor, drive motor and control circuit are protected by overload
protector (P Figure7). When the overload protector trip, do not reset it immediately without
finding out the root cause, and make sure the motor is cooling-off before reset.
Stopping the machine
9. Loosen the accelerate pedal (N, Figure7), the machine stops running.
10. Press One-Start button (D, Figure7) to stop brushes and vacuum motor. The brushes and squeegee are lifted up
from the floor automatically. The vacuum system is closed after a few seconds delay.
11. Turn the key switch to "OFF"
12. Ensure the machine is stopped.
MACHINE OPERATION (SCRUBBING AND DRYING)
1. Start the machine according to procedures in previous paragraphs.
2. Start cleaning by following procedures in section of "Starting the machine".
3. If necessary, stop the machine to adjust squeegee according to section "Adjusting the balance of squeegee".
CAUTION!
To avoid any damage to the floor surface, turn off the brush/pad-holder when the machine stop
in one place.
NOTE
For correct scrubbing/drying of floors at the sides of walls, we suggest to go near the walls with
right side (Bumper wheel side) of the machine as shown in below Figure8.
Figure 8
Figure 8
10
ENGLISH