Pioneer CJ-V51 Bedienungsanleitung Seite 5

PREPARATION
HOW TO OPEN THE MAIN
UNIT DOOR
© The upper part of the main unit door is held to the main unit
with a magnet. To open it, pull the upper part towards you.
e To remove the main unit door for connection etc., hold the
door up, and pull the two flanges located on the bottom of the
door out of the slit.
Be careful not to disturb the connection cable.
REMOVING THE
TRANSPORT SCREWS
FROM THE CD PLAYER
Ground wire
Cord binder
The vibration-protection of the CD player is fixed with three
screws for shipping.
@ Remove the screw and spacer on the front center.
(Keep the removed screw in the pocket inside the main unit
door in case it becomes necessary to move the unit again.)
@ Remove those screws on both sides of the front, and install
them to the holes indicated by the arrows.
When transporting the CD player, make sure to install the
screws for protection.
To protect the mechanisms, make sure to remove all three
magazines from the player before transport.
CONNECTION
CONNECTING THE CD PLAYER
@ Connect the CD player's CONTROL jack to the controller's
CONTROL jack with the control cord.
@ Connect the CD player's AUDIO OUT jacks to the amplifier's
AUDIO IN jacks with the audio cord.
@ Connect the CD player's power cord to the AC OUTLET of the
amplifier section.
@ Connect the ground wire to the ground terminal.
When combining with other devices (such as an
amplifier)
Connect the LINE OUT jacks located on the rear panel to the input
jacks of the other device.
Connect the LINE IN jacks located on the rear panel to the output
jacks of the other device.
CONNECTING THE POWER CORD
After completing connection of all signal lines and setting the line
voltage selector properly, connect the power cord to the wall
outlet.
5
<DRB1045 >
En