Pioneer CJ-V51 Bedienungsanleitung Seite 2

CAUTION
the product.
Location:
KINGDOM
CLASS 1
FOR USE IN THE UNITED
This product contains a laser diode of higher class
than 1. To ensure continued safety, do not remove
any covers or attempt to gain access to the inside of
Refer all servicing to qualified personnel.
The following caution label appear as indicated:
On the rear panel of the main unit
LASER PRODUCT
V RW-328
The wires in this mains lead are coloured in accordance
with the following code:
Biue: Neutral
Brown: Live
If the apparatus is fitted with AC mains power outlet(s),
see
REAR PANEL
FACILITIES
for convenient
connection of additional Hi-Fi component(s}. Make all
connections to the AC outlet(s) and the signal terminals
first. Connect the plug to the wall socket last, make
sure that the power switch is off.
WARNING: This plug must only be connected to
electronic apparatus equipped with suitable sockets.
If not, cut off the plug and fit an appropriate type in
accordance with the instructions below.
The cut-off plug must be disposed of as an electrical
shock hazard could exist if connected to a socket
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
marking identifying the terminals in your plug proceed
as follows:
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or
coloured black.
outlet.
A 2-point (220 V/230—240 V) voltage selector switch is located
VOLTAGE SELECTOR
SELECTEUR DE TENSION
Point arrow to power
230V
220V
voltage of your area
—240V
{Figure shows arrow
pointing to 230—240
volts.)
2
<DRB1045>
En
The wire which is coloured brown must be connected
to the terminal which is marked with the letter L or
coloured red.
Do not connect either wire to the earth terminal of a
three pin plug,
POWER-CORD CAUTION
Handie the power cord by the plug. Do not pull out the plug by tugging
the cord and never touch the power cord when your hands are wet as
this could cause a short circuit or electric shock. Do not place the unit,
a piece of furniture, etc., on the power cord, or pinch the.cord. Never
make a knot in the cord or tie it with other cords. The power cords
should be routed such that they are not likely to be stepped on. A
damaged power cord can cause fire or give you an electrical shock.
Check the power cord once in a while. When you find it damaged, ask
your nearest PIONEER authorized service center or your dealer for a
replacement.