Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Appliance description
Operating the hob with the sensor keys
The ceramic glass hob is operated with touch control sensor
keys. The sensor keys are operated as follows: lightly touch a
symbol on the surface of the ceramic glass plate. A buzzer will
indicate when the controls have been operated correctly.
The touch control sensor key will then be indicated as "key".
ON/OFF key
(7)
This key is used to switch the entire hob on and off. It is, as it
were, the main switch.
Power setting display
The power setting display shows the power setting which has
been selected, or:
H................ Residual heat
P................ Power boost setting
.............. Pan recognition
A................ Automatic boost function
STOP ........ Stop function
L ............... Childproof lock
.............. Keep-warm function
The corresponding cooking zone will be selected when the
power setting display is touched. The stand-by dot (9)
of the cooking zone selected will light up.
Power key
(11)
The power boost setting makes additional power available for
induction cooking zones.
STOP key
(12)
The STOP function can be used to briefly stop the cooking proc-
ess.
Timer display
and timer key (13)
For programming the automatic switch-off device (timer) and the
minute minder.
The timer is activated when the timer display is touched.
22
and power setting key (8)
Worth knowing about the slider (sensor
field)
In principle, the slider functions the same as the touch controls;
the only difference is that you can put your finger on the glass
ceramic surface and then move it around. The touch control rec-
ognises this movement and raises or lowers the display setting
(power level) in accordance with the movement.
The term "sensor field" is used to mean slider from now on.
sensor field
What must be observed when operating sensor fields?
Your finger should not be placed flat onto the glass ceramic sur-
face in order to avoid adjacent keys/sensor fields from reacting
by mistake.
finger
vitroceramic
sensor
sensor
unsuitable
Press the sensor field lightly or move your finger around
You can press the sensor field very lightly with your finger; when
this is done the setting on the display (power level) will gradually
change.
When you put your finger on the sensor field and then move it to
the left or right, the display setting will change progressively.
The faster the movement, the faster the change in the display.
touch
GB
vitroceramic
sensor
sensor
right
move
Werbung
