Herunterladen Diese Seite drucken

Beninca RF Bedienungsanleitung Seite 10

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 11
The NiMh batteries supplied with SUN.RF feature a much longer duration. They need to be re-
placed only when their rechargeable capacity is ended and must be mandatorily replaced with
similar batteries.
All batteries are considered as special waste!
Do not leave in the environment but dispose the batteries according to regulations in
force.
INDICATOR LED
LED 2, shown in Figure 3, performs the diagnostics function of the device.
Press key S1 for a short period of time:
- if the LED starts flashing, this means that the sensitive safety edge has not hit any obstacle
- if the LED switches on with fixed light, this means that an obstacle has been detected. The
transmitter is sending an alarm signal to the receiver.
IMPORTANT NOTICE
For the correct operation of the device, the following should be carefully followed:
1 The solar panel must be mounted where it will get direct sun exposure. The transparent panel
must be turned upwards.
2 Check that during the day the panel is not shaded (trees, buildings, etc.).
3 Clean the solar panel periodically from dust and dirt.
4 The better the exposure of the panel, the better the performance and reliability of the device.
If the panel is mounted in areas with little sun exposure, 2 solar panels can be connected
in parallel.
5 If correctly installed and maintained perfectly efficient, the system will be able to operate for a
very long period of time. At the end of this period, the battery should be however replaced due
to the maximum number of recharge cycle reached.
6 A correctly installed and maintained device will comply with the safety level set out be regu-
lations in force. However, the manufacturer shall be held harmless for any damages or injuries
caused by incorrect installation, incorrect maintenance, unintended or incorrect use of the de-
vice.
DISPOSAL
When the product is out of order, it must be disposed according to regulations in force on waste
disposal and recycling of the various components (metal, plastics, electrical wires, etc.). For this
purpose, it is advisable to contact your installer or a specialised company.
10

Werbung

loading

Diese Anleitung auch für:

Rf.sun