Panasonic WJ-AVE3 Bedienungsanleitung Seite 22

Instant Fade-in
When you want to return to the source image instantly
after fading-out the source image, press the VIDEO
FADE Button (29) instead of pressing the FADE START
Button (26) again.
e Fade-out
VIDEO. FADE
oa FADE START
rage loyr
are ae
7 \>
(LED blinking)
e Regular Fade-in
FADE START FADE OUT
| soe |
Ce (LED goes off}
e Instant Fade-in
VIDEO FADE
; ; rage lay
4 aS
{LED blinking)
Notes:
1. The WJ-AVES is still in the Fade-out mode (FADE
OUT LED (27) blinking) even if you operate the
Instant Fade-in mode.
2. The Instant Fade-in for Superimpose Fade and the
Audio Fade are available.
~24-
NOTES ON OPERATION
. The A/V Synchronization will be triggered by any of the
audio sources among the Source Audio tnput Signal,
the Auxiliary Audio Input Signal or the Microphone Input
Signal.
. The Superimpose Effect Block has 2 frame memories.
When other images are needed-to be stored into
memory, the previous stored image will be overridden
by new images.
. The Source Video Input (SOURCE Y/C, SOURCE
COMP) accepts both the camera signal and the VIR
playback signal. However, the Superimpose Video
Input (SUPERIMPOSE Y/C, SUPERIMPOSE COMP,)
does not accept the VTR playback signal as it is not
stable enough.
. The stored superimposed images will disappear when
you remove the AC power cord from the AC outlet on
the wall.
. When you operate the Instant Fade-in for the Audio
Fade, be sure to note that the sound will pop in
suddenly. To avoid this, the audio level should be
lowered by using the Audio Faders.