Astralpool CONTROL BASIC PLUS Handbuch Seite 5

§
§
§
§
§
Setpoint
o
Adjust value with
o
§
Setpoint Type
o
§
§
OFA Time
o
§
§
Code 0000138008
•
It's possible to enable(ON) or disable (OFF) the communication.
wdg config.
•
Adjust value with
•
It's possible to set as: Hardware Reset, Com. Reset, Stop Dosage and
WDG Alarm (default value).
rs485 watchdog
•
Adjust value with
•
It's possible to adjust the time in seconds. If it is set as OFF (default value)
the communication watchdog is disabled.
address
•
Adjust value with
•
It's possible to adjust the address of the device from 1 (default value) to 247
parity
•
Adjust value with
•
The value of the parity bit, it's possible to set as: Even (default value), Odd
or No.
baudrate
•
Adjust value with
•
The value of the speed of the transmission, it's possible to set as: 2400,
4800, 9600 (default value), 19200.
•
7.4ph
and
It's possible to adjust from 0 to 14 pH value and 0 to 1000 mV for Redox
Acid
Adjust value and
It's possible to adjust Acid or Alkaline dosing and High or Low for Redox
off
Adjust value and
It's possible to adjust OFA time in minutes
and
and
and
and
and
rev. 1.0 3