Maintenance - Hettich MIKRO 200 Gebrauchsanweisung

Disinfecting the device
Disinfecting the accessories
Autoclaving
8.5

Maintenance

Greasing the rubber seal of
the centrifuging chamber
Greasing the rubber seal of
the biosafety system
AB2400en
Disinfectant concentration and application time according
to the manufacturer's instructions.
CAUTION
Risk of injury due to ingress of water or other liquids.
−
Protect the device against external liquids.
−
Do not disinfect the device using spray.
1. Open the lid.
2. Switch off the device and disconnect it from the power supply.
3. Remove accessories.
4. Clean the housing and centrifuging chamber using disinfectant.
5. Remove any disinfectant residues with a damp cloth after using disin-
fectants.
6. The surfaces must be dried immediately after cleaning.
1. Disinfect the accessories using the disinfectant.
2. Wet all cavities with bubble-free disinfectant.
3. Remove the disinfectant residues or leave them to dry after using
disinfectants.
The following accessories may be autoclaved at 121 °C / 250 °F (20 min):
■
Swing-out rotors
■
Aluminium angle rotors
■
Metal buckets
■
Lid with bioseal
■
Inserting
No statement can be made about the resulting degree of sterility.
The lids of the rotors and bucket must be removed before autoclaving.
Autoclaving accelerates the ageing of materials. It may cause changes
in colour. After autoclaving, the rotors and accessories are to be visually
inspected for damage and any damaged parts are to be replaced immedi-
ately.
The sealing ring in question is to be replaced if there are signs of cracking,
embrittlement or wear. For lids with non-replaceable sealing rings, the whole
lid must be replaced.
The sealing rings must be replaced after autoclaving to ensure the tightness
of the biosafety systems.
Rub the sealing ring lightly with a rubber care product.
Rub the sealing ring lightly with a rubber care product.
Rev.: 12 / 11.2023
Cleaning and care
33 / 39