Short-Time Centrifugation; Quick Stop Function; Software Operation; Centrifugation Parameters - Hettich MIKRO 200 Gebrauchsanweisung

Software operation

6.5.3

Short-time centrifugation

6.6

Quick stop function

7 Software operation
7.1

Centrifugation parameters

7.1.1

Relative centrifugal force, RCF

26 / 39
3. Ramp-down takes place with the selected brake level after the time
has elapsed or if the centrifugation run is cancelled.
�� The brake level is displayed.
An audible signal sounds when the rotor comes to a standstill.
'OPEN' 'OEFFNEN' is displayed.
The right side of the
centrifuge is in ramp-down.
The left side of the
at a standstill.
The light on the
[STOP/OPEN] button go out.
Personnel:
■
Trained user
1. Press and hold the
[START/IMPULS] button lights up during the centrifugation
�� The
run.
Timing starts at 00:00.
The rotor speed or the RCF value, the temperature in the centri-
fuging chamber (only for centrifuges with cooling) and the elapsed
time are displayed during the centrifugation run.
[START/IMPULSE] button to end the centrifugation run.
2. Release the
�� Ramp-down takes place with the set brake level. The brake level is
displayed.
An audible signal sounds when the rotor comes to a standstill.
'OPEN' 'OEFFNEN' is displayed.
Personnel:
■
Trained user
[STOP/OPEN] button twice.
Press the
�� Ramp-down with brake level "9" (shortest ramp-down time) is dis-
played and executed.
The relative centrifugal force RCF is dependent on the speed and the centri-
fuging radius.
The relative centrifugal force RCF is stated as a multiple of the acceleration
due to gravity (g).
The relative centrifugal force RCF is a dimensionless numerical value and is
used to compare the separation and sedimentation performance.
Rev.: 12 / 11.2023
[STOP/OPEN] button lights up when the
[STOP/OPEN] button lights up when the rotor is
[START/IMPULS] button and the right side of the
[START/IMPULS] button.
AB2400en