Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4
Maintenance and Cleaning
The modules are maintenance-free. Please note the following when cleaning the
housing:
Before cleaning, disconnect the equipment completely.
l
Clean the housing with a soft, slightly damp (not wet) cloth. Never use
l
solvents, since these could damage the labeling on the front panel and the
display.
Do not apply high water pressure to the unit for cleaning.
l
General Dangers of Failing to Follow the Safety Instructions
The module is a state of the art device and, as such, is fail-safe. The module may
give rise to further dangers if it is inappropriately installed and operated by
untrained personnel. Any person instructed to carry out installation,
commissioning, maintenance or repair of the module must have read and
understood the User Manuals and in particular the technical safety instructions.
Remaining Dangers
The scope of supply and performance of the module covers only a small area of
measurement technology. In addition, equipment planners, installers and
operators should plan, implement and respond to the safety engineering
considerations of measurement technology in such a way as to minimize
remaining dangers. Prevailing regulations must be complied with at all times.
There must be reference to the remaining dangers connected with measurement
technology. After making settings and carrying out activities that are password-
protected, you must make sure that any controls that may be connected remain in
safe condition until the switching performance of the module has been tested.
Working Safely
Error messages should only be acknowledged once the cause of the error is
removed and no further danger exists.
Conversions and Modifications
The module must not be modified from the design or safety engineering point of
view except with our expressed agreement. Any modification shall exclude all
liability on our part for any resultant damage.
In particular, any repair or soldering work on motherboards or replacement of
components is prohibited. When exchanging complete modules, use only original
parts from HBM.
The module is delivered from the factory with a fixed hardware and software
configuration. Changes can only be made within the possibilities documented in
the manuals.
Qualified Personnel
Qualified persons means persons entrusted with the installation, fitting,
commissioning and operation of the product who possess the appropriate
qualifications for their function. This module is only to be installed and used by
qualified personnel, strictly in accordance with the specifications and the safety
rules and regulations.
SomatXR
A4087-3.0 en/de
Werbung
