Bergstrom Integral Power II Benutzerhandbuch Seite 11

INTEGRAL POWER II
Remote control
Remote control functions:
1
Unit on/off.
Note: This key is used to run the unit in automatic
mode F4
2
Centrifugal blower speed control (Manual mode only):
Note: with the unit running in automatic mode F4 , the unit will
pass into manual mode F0 . when this key is pressed. Users
can therefore use this key to choose the required airflow, with
the display showing U1 , U2 , U3 , U4 , U5 , U4 , U3 , U2 , U1 .
3
Temperature control: Comfort temperature can be controlled
by briefly pressing the keys
Registering the remote control:
To register the remote control, keep the key
with the unit off. The display will flash
key on the remote control within 30 seconds and the unit will give out an acoustic
signal as confirmation. If this does not happen, repeat the whole operation.
(15/27ºC - 59/80ºF).
-
of the control panel pressed down
C
.When it stops flashing, press the On/Off
11
EN
1
3
2