Mounting and Installation
DE
6
Mounting and Installation
EN
FR
6.1
Mounting/Dismounting
▶
Mount the device carefully and only in accordance with the safety notes
IT
(see the "Safety" chapter).
ES
▶
Read through the following installation conditions and assembly instructions carefully and
RU
follow them precisely.
NL
6.1.1 Operating Position
▶
DK
Install the device on a level surface only, so that it is not subjected to torsion.
▶
Secure the device using the anchoring brackets. Refer to the dimensional drawing for the
SE
dimensions of the mounting holes.
FI
▶
Align the enclosure depending on the mounting type or further documentation:
PT
• For vertical mounting: Any orientation
• For horizontal mounting: Cover on top
GR
• The device must not be suspended above the ground and the cover must not be at an
PL
angle.
• Take into account the clearance that is required to open the cover.
CZ
SK
HU
SL
RO
BG
LV
LT
6.1.2 Environmental Installation Conditions
EE
▶
If the explosion-protected equipment is exposed to the weather, it is advisable to provide
CH
a protective roof.
KR
▶
Equip explosion-protected electrical equipment with a breather and drain valve in order to
prevent the vacuum effect. Observe the correct mounting orientation when doing so;
CN
see also chapter 6.1.1.
▶
Do not create any cold bridges (condensation hazard). If necessary, install the enclosure
with a clearance to minimise condensation in the enclosure.
12
Junction boxes
Series 8118
≦ 90°
16523E00
133275 / 8118605300
2023-08-10·BA00·III·en·09