Endress+Hauser SFG500 Schnelleinstieg Seite 7

3 Installation
• To avoid malfunction of Fieldgate SFG500, mount and configure it as described
below
• When mounting and wiring the components in a cabinet, make sure that the
layout conforms to your company or national regulations regarding the
separation of Ex and non-Ex components and circuits as well as the separation of
signal and power lines
1. Fieldgate SFG500 must be mounted in a permanent and weather-protected
location in a safe area. Recommended is a metal cabinet or an installation frame
with a well grounded mounting plane.
2. Adjust the DIN rail clip
mm (inch)
2
1
Endress+Hauser
m to the desired height (held by the two screws n ).
2
1
5