Endress+Hauser SFG500 Schnelleinstieg Seite 13

5.2 Insert the Fieldgate Module SFM500
• Once a Fieldgate Module SFM500 had been inserted and Fieldgate SFG500 has
been powered up it can only be removed by the procedure described in Operating
Instructions BA00070S/04/en on the CD-ROM. A failure to do this may cause
corruption of the licence and application data, in which case the Fieldgate
SFG500 will not operate.
1. If a Fieldgate Module SFM500 was ordered with Fieldgate SFG500, insert it into
the card slot in the front panel.
2. Insert as shown below
– Fieldgate Module SFM500 must be unlocked
SFG500
– Make sure that the module not inserted at an angle
Endress+Hauser
Power PB DP RS485
Run PB Err LAN 1
Failure LAN 2
Reset
Fieldgate Module
SFM500
Unlocked
Entsperrt
11