Endress+Hauser SFG500 Schnelleinstieg Seite 14

5.3 Connect to Web Server
1. Power up Fieldgate SFG500
– Wait approx. 3 seconds until the Fieldgate SFG500 is ready for operation
(the yellow Run LED lights continuously)
2. Connect the laptop to the LAN2 port of Fieldgate SFG500
24 VDC
–
+
Power PB DP RS485
Run PB Err LAN 1
Failure LAN 2
Reset
SFG500
3. Before starting your web browser:
– Check that any proxy server is switched off
– Check that your computer interface is configured to accept an address from a
DHCP server
– If this is not the case, change the settings as described Operating Instructions
BA00070S/04/en on the CD-ROM
(you will need adminstrator rights for your computer to do this)
4. In your Web browser enter the address of Fieldgate SFG500 LAN2 port:
192.168.253.1 and press Enter:
12 Endress+Hauser