Skoda Rapid Montageanleitung Seite 14

- 10, 11, 12 -
Fastening the parking sensor wires
- Place fasteners (H) on the bumper stiffener, approximately to the places shown on the
figure.
- Proceed as follows to fix the sensor wires in the fasteners:
- first fastener - all 3 wires,
EN
- second fastener - 2 wires (the shortest remains loose),
- third and fourth fastener - 1 wire (the middle one remains loose).
- Then additionally fasten all wires on the bumper beam using three foam adhesive tapes (L)
-arrows-.
Advice. Fasten all wires in such a way that the end with the connector
remained loose, in a length of about 30 cm.
If the vehicle has a mounted towing coupling, use tightening tapes (J
of the kit to fix the parking sensor wires. Place the tightening tapes
approximately to places that were used when fastening the wires on
the rear bumper stiffener.
- Snap the cable terminal boards in the parking sensor terminal board, and refit the rear
bumper.
- 13, 14, 15 -
Fastening the loudspeaker
- Remove the blind flange off the roof panel and put it to sorted garbage.
- Run the loudspeaker wires (C) through the hole in the roof panel towards the left C-pillar (in
the direction of the drive).
- Then turn the loudspeaker in such a way that the LED diode was directed towards the
interior of the vehicle. Snap in the loudspeaker.
Caution. In running the wires from the loudspeaker under the roof
panel proceed as advised by the authorized service shop. Be careful
when running the cable through to avoid damage (break) of the roof
panel of the vehicle.
- 16, 17 -
Fixing the loudspeaker wire on the C-pillar; connection of wires
- Fasten the loudspeaker wires on the C-pillar using the foam adhesive tape (K).
- Slide the loudspeaker wire tubes to relevant spots in the parking sensor harness terminal
board. Connect the terminal board to the control unit.
- 18, 19 -
Connection of brown and black/blue wire, fastening of the control unit.
- Connect the wires to the rear combined lamp as shows the scheme on the figure.
- Fasten the connected terminal board to the existing installation of the vehicle with
a tightening tape (J) -detail- to prevent it from getting loose during driving.
- Glue the control unit onto the rear wheel cover.
14
)
1