Hitachi CSNET MANAGER XT Installations- Und Betriebshandbuch Seite 64

Operation and configuration of packaged units
4.6.11 Power meter
Power Meter tab lets the user configure a TCP-MODBUS power meter for each outdoor unit.
For each power meter device there should be entered the following parameters:
• IP Address: LAN address of the power meter.
• Power Meter ID: identifier to know which of the power meters is used.
• Registers: The Modbus Address and the measurement unit of each of the four variables available on the table should be
configured by the user according to the specific power meter information.
!
C A U T I O N
• Suggested device tested by Hitachi is 7KM PAC3200 by Siemens.
• Ensure that your Modbus-TCP power meter register starts at 0. CSNET Manager considers it like this, so if it starts at 1, subtract 1 to each register
address.
• If CSNET Manager device is off it will not get power data.
58 PMML0303A rev.2 - 02/2015