Hitachi CSNET MANAGER XT Installations- Und Betriebshandbuch Seite 52

Operation and configuration of packaged units
Address
Name
(Note 1)
8 SET_CENTRAL
9 READ_ONOFF
10 READ_MODE
11 READ_FAN
12 READ_TSET
13 READ_LOUVER
14 RCS_GROUP
15 TIN
16 TOUT
17 TGAS
18 TLIQUID
19 ERROR_CODE
20 STOP_CAUSE
21 VALVE_OPEN
22 OPER_CONDITION
23 DEFROST
24 AMBIENT_TEMP
25 RCS_TEMP
26 TIMER_DISABLED
27 OPTIONS
28 POWER
29 COMP_QTY
30 COMP_FREQ
31 REM_TEMP
?
N O T E
1 Offset position is: 20000 + N*32 + Address as shown in table, where N is unit address. Unit address as set in CSNET Manager BMS
configuration dialogue. Be careful because we are using address 0 as first register and in Mobdus could be used number 1 as first value. In that
case, it will be necessary to add 1 to the address calculation.
2 These numbers refer to signed 16-bit value using 2-complement format for negative values.
3 In case that the installation will use more than one CSNET Manager, it will use different device Ids, using Virtual Ids. Refer to the configuration
of your BMS to Ethernet adapter to know how it works.
4 Register number 10 is used for general alarm status.
5 Running compressor quantity is only valid for units with more than one compressor.
46 PMML0303A rev.2 - 02/2015
Description
Central Setting:
Bit 0: ON/OFF (always can be stopped)
Bit 1: Mode
Bit 2: Setting temperature
Bit 3: Fan
ON/OFF read:
0: OFF
1: ON
Mode read:
0: Cool
1: Dry
2: Fan
3: Heat
4: Auto
Fan read
0: Low
1: Medium
2: High
Setting temperature read
(17ºC to 30ºC)
Louver read
0 ~ 8 (8 is Auto)
Remote controller group
0 ~ 255
Inlet temperature (Note 2)
Outlet temperature (Note 2)
Gas pipe temperature (Note 2)
Liquid pipe temperature (Note 2)
Alarm code
Compressor stop cause
Indoor unit expansion valve opening
Unit operation condition
0: OFF
1: Thermo OFF
2: Thermo ON
3: Alarm
Defrost
Ambient temperature (Note 2)
Remote control switch temperature
(Only when available in unit) (Note 2)
Timer disabled
0: Disabled
1: Enabled
Options setting
Calculated power consumption
Running compressor quantity (Note 5)
Inverter compressor frequency
Remote sensor temperature
(Only when accessory is installed) (Note 2)
Read/Write
Read/Write
Read
Read
Read
Read
Read
Read
Read
Read
Read
Read
Read
Read
Read
Read
Read
Read
Read
Read/Write
Read
Read
Read
Read
Read