Hitachi CSNET MANAGER XT Installations- Und Betriebshandbuch Seite 46

Operation and configuration of packaged units
!
C A U T I O N
The network settings specify the parameters for configuring CSNET Manager to be able to communicate with the rest of the network. These parameters
are essential, and a bad configuration may cause conflicts in the local area network. This is why we recommend that for making these settings you get
in touch with the network administrator where CSNET Manager will be installed.
To enter and/or modify the network configuration click on
steps:
1 Enter the IP address. The IP address consists of four numbers which must be between 0 and 255.
2 Enter the Mask. As in the case of the IP address, the four numbers must be between 0 and 255.
3 Enter the IP address of the Gateway. Again, the numbers for these four fields follow the same rule as the IP address and Mask. If
you do not have a Gateway, the field should contain an IP address within the margins of the specified network.
4 Click on the (OK) button situated in the upper right (by the IP line). A message will appear as in the example:
5 When you press the OK button, the system will ask for confirmation of setting update. CSNET Manager will restart and therefore
communication with it will be lost by approximately 2 minutes.
If harc is doing auto-configuration, it will not be able to modify settings from that pane. User must wait for the end of auto-
configuration.
40 PMML0303A rev.2 - 02/2015
button (Change) in Network settings section and follow these
OK