Hitachi CSNET MANAGER XT Installations- Und Betriebshandbuch Seite 25

Installation
2.2.2 Stand Mounted (Optional)
!
C A U T I O N
This device cannot built in neither installed without providing ventilation to
the aluminium sink behind.
CSNET Manager can be stand mounted by using any standard
VESA 75 mm stand mounted support for LT & XT and VESA 100
mm for XT only. HITACHI offers the following stand mounted
accessory VESA 75, model code 7E512301.
The stand comes disassembled in 2 parts:
4 screws
Base
1 Place the fixing screen support 90 degrees with respect to its
arm.
2 Put the screen upside down and insert the 4 stand screws on
the rear of the screen (the power source connector will be at
the bottom of the screen). There are 8 holes on the support,
4 for the LT screen and the other 4 for the XT screen.
Screws
2.3 CONNECTORS DESCRIPTION
Label Function
POWER Power on button
Compact CF Type I/II Socket with
Flash/COM2 Ejector
COM1 Serial port 1 connector
LINE OUT Line-out audio jack
USB 2 x USB 2.0 connector
RJ-45 Ethernet
LAN1
connector 1
19 PMML0303A rev.2 - 02/2015
Fixing
screen
support
Arm
Arm
Fixing screen
support
Screen
Note
Optional for 2nd
COM port
DB-9 male
connector
Dock USB
!
C A U T I O N
In order to avoid damage to the screen, protect it before setting it upside
down.
3 Screw the rear support screw to the arm and the stand will
be completely mounted.
Rear support screw
4 Finally, connect the power supply and LAN cable to the
CSNET Manager.
5 Press down the power switch.
6 CSNET Manager program starts automatically.
Label Function
LPC-1705/1707 -- PS/2
KB/MS
connector
(LAN2)
LPC-17A4 -- LAN2
HDD HDD indicator
PWR System power indicator
CRT connector/HDMI
VGA/HDMI
connector
RESET Reset button
DC-IN DC Power-in connector
Note
For CSNET
Manager XT it
is a LAN2 (RJ-
45 Ethernet
connector)