Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

• If the vehicle tends to pull to the left or right instead of driving
straight ahead, you can adjust straight running at the vehicle.
For this, there is a small lever at the bottom of the front axle
that can be moved to the right and left.
Adjust this lever so that the vehicle runs approximately
straight.
Only adjust this lever a little at a time and then check if the
vehicle runs straight.
• Stop driving immediately if the vehicle shows any unusual responses to the remote commands or if the vehicle does
not respond at all. This behaviour could be caused by low drive batteries, low batteries/rechargeable batteries in the
remote control or by too great a distance between vehicle and remote control.
Interferences on the radio channel used (e.g. radio transmissions from other devices, Bluetooth
adverse transmission/reception conditions may also cause unusual responses of the vehicle.
Since the receiver is supplied with power through the drive battery in the vehicle, low or empty drive batteries will
cause unintentional movement of the vehicle.
Wait for at least 5 - 10 minutes until the drive has cooled down sufficiently before the next run. Only then start a
new drive with a full drive battery.

e) Stopping the Vehicle

To stop driving, proceed as follows:
• Let go of the lever (E) on the transmitter so that it goes into the middle position (neutral position) and let the vehicle
run out. Release the turning wheel (C).
• After the vehicle has stopped, switch off the vehicle with the on/off switch (L) on the bottom (switch position "OFF").
Attention!
Never touch the wheels or the drive mechanism, and make sure you do not move the lever (E) or the turn-
ing wheel (C) at the transmitter! Do not hold the vehicle at its wheels!
• Switch the transmitter off via the on/off switch (A) (switch position "OFF").
Always proceed in this order - first switch off the vehicle, then the transmitter.
If not used for a longer period (e.g. in case of storage), remove the drive battery from the vehicle. Other-
wise, the battery may leak. Disconnect the connection between the drive battery and the vehicle entirely.
Also remove any batteries from the transmitter.
Charge the drive battery after using the vehicle. If the vehicle is not used for an extended period (e.g. during
winter storage), make sure that the drive battery is charged every 2 - 3 months to prevent harmful deep
discharge. Deep discharge may damage the drive battery and render it useless.
, WLAN) or
®
33

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

1:10 rock-crawler 4wd 2,4 ghz rtr

Inhaltsverzeichnis