Heidolph Safe Aufbauanleitung Seite 19

Operation
Setup, Positioning
Thanks to their robust design and the self-locking scissor mechanism, the lab jacks, type e-Lift,
offer the best stability and occupational safety.
Follow the safety instructions below:
➜
To use the lab jack, place it on a clean, dry, stable, even and horizontal surface.
➜
Always make sure that all setup components and accessory parts of the magnetic stirrer
are securely fixed (see also the corresponding delivery documentation or operating and/or
mounting instructions):
➜
Fix the setups preferably on a wall grid (if available). When mounted on a wall grid, ensure
that the wall grid and all mounting elements have sufficient self-protection and load
capacity!
➜
Use all recommended retaining and fixing elements for setup components and accessory
parts.
➜
The lab jack, the magnetic stirrer and any other setups do not form a physical unit and
must always be transported separately.
➜
Before each transport, disconnect the cable connection between the lab jack and the
magnetic stirrer.
Magnetic stirrer – lab jack cable connection
The lab jack [2] is connected to the USB-C connection socket at the back of the magnetic stirrer
[1] using the USB-C cable supplied:
As soon as the lab jack has been detected by the software, the corresponding symbol appears
on the display of the magnetic stirrer:
In case of interruption of the data connection between the lab jack and magnetic stirrer, the
following warning appears on the display of the magnetic stirrer [73: Lab jack has no connec-
tion] and the [Lab jack connected] symbol goes out.
19