cecotec Cumbia POWER ESPRESSO 20 STEEL PRO Bedienungsanleitung Seite 50

ENGLISH
4. CLEANING AND MAINTENANCE
Regular cleaning and maintenance guarantee that the coffee machine works properly and
ensure that the coffee taste is optimal, that there is a constant flow of coffee and that the
milk froth is excellent for a long time.
Cleaning the filter holder and filters
Keep the filter holder and filters clean to ensure optimal results.
WARNING: to avoid burns, remove the filter only when the filter holder has cooled down
completely.
Remove the filter from the holder and wash it with warm water.
1.
2. If you notice any faults when brewing coffee, immerse the filter in boiling water for 10
minutes and then rinse it with tap water.
Cleaning the steamer
1. Immediately after frothing the milk, turn the steam regulator knob to remove any milk
residue from the steamer.
2. Clean the steamer with a damp cloth. To clean it more thoroughly, you can unscrew the
steamer and wash it with tap water.
3. If the steam nozzle orifice becomes clogged, make sure that the steam regulator knob is
in standby mode. To switch off the machine, press the power button. Use a pin to unclog
the hole.
Cleaning of the head where the filter holder is placed
Regularly remove ground coffee residue from the coffee head with a brush and wash it with
hot water following the steps below.
1. Insert the filter holder into the machine upper part without ground coffee.
2. Place an empty cup under the brewer head.
3. Press the double cup button and fill the cup with water.
4. Remove the filter holder from the brewer head and clean it with a dry cloth.
WARNING: do not attempt to disassemble the brewer head. It will damage the head and may
cause leakage.
Descaling
To ensure that your coffee machine works properly and that the taste of your coffee is
preserved, it is necessary to descale, clean and check the machine periodically.
In addition, after 500 times of preparation cycle, a descaling warning will appear. The power
button will flash 5 times to indicate that the machine needs to be descaled. The descaling
warning will appear every time you switch on the machine if you do not run the cycle.
50