Herunterladen Diese Seite drucken

cecotec Cumbia POWER ESPRESSO 20 STEEL PRO Bedienungsanleitung Seite 45

Vorschau ausblenden Andere Handbücher für Cumbia POWER ESPRESSO 20 STEEL PRO:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 67
-
Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
-
Wash the water tank with its cover, the pressing powder spoon and filter as well as the
filter holder with lukewarm water and a little neutral dishwashing detergent. After that,
rinse with clean water and dry.
-
Also, clean the housing of the espresso machine and the drip tray with its grille with a
soft, damp cloth and dry all parts.
Box content
-
Power Espresso 20 Steel Pro espresso machine
-
Filter holder
-
1 cup filter
-
2 cups filter
-
Coffee spoon
-
Instruction manual
3. OPERATION
1. Fill the water tank with cold water up to the MAX mark on the deposit.
2. Connect the plug to a socket that has a suitable voltage.
3. Press the power button. Next, the indicator light will turn on and the espresso machine
will automatically start to preheat. Once the preheating process is completed, all buttons
will light up steadily. The preheating process takes about 2 minutes.
4. Put a cup under the steamer. Turn the steam regulator knob. Let hot water run out of the
steamer for about 8 seconds and then, turn the steam regulator knob to the off position.
This process allows the water to pass through to the pump the first time it is used.
ATTENTION: the first time you use the espresso machine it may make a loud noise or vibrate.
This is normal for a 20 bar pressure pump. When you use it again, it will make less noise.
5. Put the filter in the filter holder.
ATTENTION: you may find it a little difficult to remove the filter from the filter holder when you
want to change it. You can use another filter for leverage.
6. Insert the filter holder without ground coffee into the upper part of the espresso machine
by making a 45° movement to the left and turn it back to the right until it clicks into
position. The filter holder must be perpendicular to the machine or slightly inclined to the
right.
POWER ESPRESSO 20 STEEL PRO
ENGLISH
45

Werbung

loading