Led Flashing Sequences And Transmission Behaviour - HomeMatic HM-PB-2-WM55-2 Montage- Und Bedienungsanleitung

BRIGHTER. Dimming occurs by holding the button
pressed.
• If you want to exit configuration mode, press the
teach button again.
If no teaching occurs, teach mode is
automatically ended after 20 seconds. If
another device is in teach mode, this is taught.
If the push button is already taught for a
center and therefore is blocked for direct
training, it can still be put in configuration
mode as described above, the device LED is
illuminated in red for 2 seconds after pressing
an operating button however. Direct teaching
is not possible!
After teaching, in the operation mode simple opera-
ting functions are available. The 2 buttons (on a com-
mon rocker) can be controlled by pressing up or down
( ) shortly. Pressing up ( ) triggers the functions ON,
UP or BRIGHTER, pressing down
( ) triggers the functions OFF, DOWN or DARKER.
Switch actuators and dimmers can then be switched
ON/OFF. Furthermore, dimming occurs by holding the
button pressed and blind actuators move up or down.
38
7.3 LED flashing sequences and transmission
behaviour
The LED's flashing sequences have different mea-
nings:
Flashing sequence
Min. 2s green LED
2s red LED
Orange flashing
Brief orange flashing and
2s red or green (depen-
ding upon success)
Short orange/short green
flashing
Push button in configura-
tion mode and illuminated
red with button actuation
Meaning
Teaching successful
Teaching failed
Only rocker button in
teach mode
Other device in teach
mode and rocker button
put in teach mode
Signal is being send/
confirmed
Push button already
taught for center and is
therefore blocked from
direct teaching
39