Error Codes And Flashing Sequences; Restore Factory Settings - HomeMatic HMIP-WRC2 Montage- Und Bedienungsanleitung

Troubleshooting
7.4

Error codes and flashing sequences

Flashing code Meaning
Short orange Radio transmis-
flashing sion/attempting
to transmit
1x long green Transmission
lighting confirmed
1x long red Transmission
lighting failed
Short orange Teach-in mode
flashing (every active
10 seconds)
Short orange Battery empty
lighting (after
green or red
confirmation)
1x long red Duty cycle
lighting exceeded or
transmission
failed
42
Solution
Please wait, until
transmission has
been confirmed.
You can continue
operation.
Please try again (s.
„7.2 Command not
confirmed" on page
40).
Please enter the last
four numbers of the
device serial number
to confirm (s. „5.1
Teaching-in" on
page 32
Replace the batteries
of the device (see „6
Replacing batteries"
on page 38).
Please try again
(see „7.2 Command
not confirmed" on
page 40 or „7.3
Duty cycle" on page
41).
6x long red Device defec-
flashing tive
1x orange Test display
and 1 x green
lighting (after
inserting bat-
teries)
8

Restore factory settings

The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the wall-mount remote
control, please proceed as follows:
• To remove the remote control (B) from the frame,
take hold of the sides of the remote control and
pull it out (see figure 5).
• Remove the (old) batteries.
• Insert the batteries ensuring that the polarity is
correct (see figure 6) while pressing and holding
down the system button (D) for 4s at the same
time, until the LED will quickly start flashing or-
ange (see figure 7).
• Release the system button again.
• Press and hold down the system button again for
four seconds, until the status LED lights up green.
Restore factory settings
Please see your app
for error message or
contact your retailer.
Once the test
display has stopped,
you can continue.
43