Installation; Scope Of Delivery; Adhesive Strip Mounting - HomeMatic HM-PB-2-WM55-2 Montage- Und Bedienungsanleitung

The range of transmission within buildings
can greatly deviate from open air distances.
Besides the transmitting power and the reception
characteristics of the receiver, environmental
influences such as humidity in the vicinity and local
structures also play an important role.
Hereby, eQ-3 AG declares that this device conforms
with the essential requirements and other installation
site as desired conforming with the relevant regulati-
ons of directive 1999/5/EG.
The full declaration of conformity is provided under
www.HomeMatic.com.
6

Installation

6.1 Scope of delivery

Push button assembled:
• Mounting plate
• Attachment frame
• Electronic unit with rocker button
Accessories:
• Adhesive strips for wall mount
• 2 wood screws 3.0 x 30 mm
30
• 2 wall anchors 5 mm
• 2 LR03 batteries (micro/AAA/LR03)
You can either use screws or adhesive strips to mount
the HomeMatic push button to a wall in the frame
supplied or integrate it into an existing switch (see sec.
6.4 for suitable switches).

6.2 Adhesive strip mounting

• Choose a site for installation. The surface on
which you are mounting the push button must be
clean, dry and greaseless.
• For mounting of the assembled push button,
attach the adhesive strips to the back side of the
mounting plate. You should be able to read the
letters on the back side (according to figure).
<PA66>
31