Screw Mounting; Installation In Multiple Combinations - HomeMatic HM-PB-2-WM55-2 Montage- Und Bedienungsanleitung

• Remove the protective film from the adhesive strip.
• Press the assembled push button with the back
side to the wall in the position where it should
subsequently be attached.

6.3 Screw mounting

• Choose a site for installation.
• Make sure that electrical lines in the wall will not
be damaged.
• Position the mounting plate on the desired site on
the wall. Make sure that the arrow on the mounting
plate is pointing upwards.
• Use a pen to mark the positions of 2 bore holes A
(diagonally opposite) in the mounting plate on the
wall. The bore holes B can be used for installation
with a flush-mounting box.
A
B
32
B
A
B
B
• If you are working with a stone wall, drill the mar-
ked two 5 mm holes and insert the plugs supplied.
If you are working with a wooden wall, you can
pre-drill 1.5 mm holes to make screws easier to
insert.
• Use the screws and plugs supplied to fasten the
mounting plate to the wall.
• Next, attach the frame to the mounting plate.
• Attach the push button. Make sure that the arrows
on the back side point upwards and that the clips
on the mounting plate latch into the openings on
the electronic unit.

6.4 Installation in multiple combinations

You can mount the push button with the attachment
frame provided or use it with frames of other manuf-
acturers as well as integrate the electronic unit into a
multi-gang frame. In both cases, mounting with adhe-
sive strips and screws is possible. For mounting with
multiple combinations, make sure that the mounting
plate of the push button is seamlessly aligned to the
already fixed mounting plate/retaining ring.
The HomeMatic push button is designed to fit into
frames supplied by the following manufacturers:
33