General System Information; Start-Up; Teaching-In - HomeMatic HMIP-WRC2 Montage- Und Bedienungsanleitung

General system information

4 General system information
This device is part of the climate control solution of
Homematic IP and works with the HmIP radio protocol.
All devices of the climate control solution can be config-
ured comfortably and individually with a smartphone via
the Homematic IP app. The available functions provided
by the Homematic IP system in combination with other
components are described in the Homematic IP User
Guide. All current technical documents and updates are
provided at www.eQ-3.de.
5

Start-up

5.1

Teaching-in

Please read this entire section before starting
the teach-in procedure.
First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, please refer to the oper-
ating manual of the Access Point.
To integrate the wall-mount remote control into your
system and enable it to communicate with other Home-
matic IP devices, you must teach-in the device to your
Homematic IP Access Point first.
32
To teach-in the wall-mount remote control, please pro-
ceed as follows:
• Open the Homematic IP app on your smart-
phone.
• Select the menu item "Teach-in device".
• To remove the remote control (B) from the frame,
take hold of the sides of the remote control and
pull it out (see figure 5).
• Turn over the remote control.
• Insert two new 1.5 V LR03/micro/AAA batteries
into the battery compartment, making sure that
you insert them the right way round (see figure 6).
Teach-in mode remains activated for 3 minutes.
You can manually start the teach-in mode for an-
other 3 minutes by pressing the system button
(D) shortly (see figure 7).
• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the LED lights up
green. The device is now ready for use.
• If the LED lights up red, please try again.
Start-up
33