Herunterladen Inhalt Inhalt Diese Seite drucken

Replacing Batteries - HomeMatic HMIP-WRC2 Montage- Und Bedienungsanleitung

Wandtaster - 2-fach
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Replacing batteries

mode / Wall-mount remote control".
You can define the rooms for activating the eco
mode and lowering the temperature by tapping on
"Rooms in eco mode".
The temperature for the eco mode can be defined
under "Eco temperature".
To activate the eco mode via the wall-mount re-
mote control you can define the duration under
"Eco duration via wall-mount remote control".
When leaving home, simply push the Homematic IP Wall-
mount Remote Control or slide the switch in the home
screen of your app from "Auto" to "Eco" to activate the eco
mode.
6
Replacing batteries
If an empty battery is displayed via the app or the device
(see „7.4 Error codes and flashing sequences" on page
42), replace the used batteries by two new LR03/mi-
cro/AAA batteries. You must observe the correct battery
polarity.
To replace the batteries of the wall-mount remote con-
trol, please proceed as follows:
Once mounted, the remote control can easily be
pulled out of the frame (A) or removed from the
mounting plate (F). To remove the remote control
38
(B) from the frame, take hold of the sides of the
remote control and pull it out (see figure 5). You
do not need to open the device.
Turn the remote control over to remove the bat-
teries.
Insert two new 1.5 V LR03/micro/AAA batteries
into the battery compartment, making sure that
you insert them the right way round (see figure 6).
Put the remote control back into the frame. Make
sure that "TOP" and the arrows on the back side
point upwards and that the clips on the mount-
ing plate latch into the openings on the remote
control.
Please pay attention to the flashing signals of the
device LED while inserting the batteries (see „7.4
Error codes and flashing sequences" on page
42.
Once the batteries have been inserted, the wall-mount
remote control will perform a self-test (approx. 2 sec-
onds). Afterwards, initialisation is carried out. The LED test
display will indicate that initialisation is complete by light-
ing up orange and green.
Never recharge standard batteries. Do not throw
the batteries into a fire. Do not expose batteries to
excessive heat. Do not short-circuit batteries. Do-
ing so will present a risk of explosion.
Replacing batteries
39

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis