hillvert HT-MD-300B Bedienungsanleitung Seite 34

Do not store the machine with fuel in a non-ventilated area where fuel fumes may reach
flame, sparks, pilot lights or any ignition sources.
DISPOSING OF USED DEVICES:
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device
recycling and collection point. Check the symbol on the product, instruction manual and packaging. The
plastics used to construct the device can be recycled in accordance with their markings. By choosing to
recycle you are making a significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
TROUBLESHOOTING:
Problem
1. Spark plug wire disconnected
2. Out of fuel or stale fuel.
Engine fails to 3. Choke not in open position.
start. 4. Blocked fuel line.
5. Fouled spark plug.
6. Engine flooding.
1. Spark plug wire loose.
2. Unit running on CHOKE.
3. Blocked fuel line or stale fuel.
Engine runs
4. Vent plugged.
erratically.
5. Water or dirt in fuel system.
6. Dirty air cleaner.
7. Improper carburettor adjustment.
1. Engine oil level low.
2. Dirty air cleaner.
Engine overheats.
3. Air flow restricted.
4. Carburettor not adjusted properly.
Machine does not
1. Gear is not properly selected.
move while
2. Drive belt not tight enough.
engine is running.
EN
Possible cause Solution
1. Attach spark plug wire securely to
2. spark plug.
3. Fill with clean, fresh gasoline.
4. Throttle must be positioned at
choke
5. for a cold start.
6. Clean the fuel line.
7. Clean, adjust gap, or replace.
8. Wait a few minutes to restart, but
do
9. not prime.
1. Connect and tighten spark plug
wire.
2. Move choke lever to OFF.
3. Clean fuel line. Fill tank with clean,
fresh gasoline
4. Clear vent.
5. Drain fuel tank. Refill with fresh
fuel.
6. Clean or replace air cleaner.
7. Refer to Engine Manual.
1. Fill crankcase with proper oil.
2. Clean air cleaner.
3. Remove housing and clean.
4. Refer to Engine Manual.
5.
1. Ensure gear lever is not in-
between two different gears.
2. Tighten drive belt.