Herunterladen Diese Seite drucken

LD Systems MAILA SPA Bedienungsanleitung Seite 5

Vorschau ausblenden Andere Handbücher für MAILA SPA:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 23
DANGER:
1. Do not operate the device if it has been exposed to severe temperature fluctuations (e.g.
after transport). Humidity and condensation could damage the device. Do not switch on
the device until it has reached the ambient temperature.
2. Make sure that the voltage and frequency of the mains supply correspond to the values
indicated on the device. If the device has a voltage selector switch, do not connect the
device until this is set correctly. Only use suitable power cords.
3. To disconnect the device from the mains at all poles, it is not enough to press the on/off
switch on the device.
4. Ensure that the fuse used corresponds to the type printed on the device.
5. Make sure that appropriate measures against overvoltage (e.g. lightning) have been
taken.
6. Note the specified maximum output current on devices with a power out connection.
Make sure that the total power consumption of all connected devices does not exceed
the specified value.
7. Only replace pluggable mains cables with original cables.
DANGER:
1. Danger of suffocation! Plastic bags and small parts must be kept out of the reach of
people (including children) with reduced physical, sensory or mental abilities.
2. Danger from falling! Make sure the device is installed securely and cannot fall. Only use
suitable tripods or attachments (especially for fixed installations). Make sure accessories
are properly installed and secured. Make sure that the applicable safety regulations are
observed.
WARNING:
1. Only use the device in the manner intended.
2. Only operate the device with the accessories recommended and intended by the
manufacturer.
3. During installation, observe the safety regulations applicable in your country.
4. After connecting the device, check all cable routes to avoid damage or accidents,
e.g. B. to avoid tripping hazards.
5. Be sure to observe the specified minimum distance to normally flammable materials!
Unless this is explicitly stated, the minimum distance is 0.3 m.
ATTENTION:
1. There is a risk of jamming with moving components such as mounting brackets or other
moving components.
2. In the case of devices with motor-driven components, there is a risk of injury from the
movement of the device. Sudden device movements can lead to startle reactions.
5

Werbung

loading

Diese Anleitung auch für:

Ldmailaspa